Cart 0 Item(s) - $0.00

DTB-PRO Drum Trigger

Convert your acoustic drum kit into the best electronic kit you could want! Available for drum shell sizes 18 inch to 22 inch.

Install the DT-PRO triggers in your toms and connect them to your drum module and you're ready to rock. It's that simple!

DTB-PRO Triggers can be connected to Roland®, 2Box®, Pintech® or Alesis® drum modules.

Unique System
Unlike other triggers, the DTB-PRO trigger is hung inside the drum shell.  The trigger is placed on a special X-shaped ribbon which is connected to the rim. This ribbon is so thin that it won't muffle your sound, even when using a standard acoustic drum head instead of a mesh head. The trigger sits on a balance plate which assures proper balance and correct trigger placement for perfect response. This method of installation has other advantages, as well. With the DTB-PRO triggers, crosstalk is a thing of the past. Crosstalk is a common problem with most drum triggers on the market, especially when using normal cymbals mounted on the same rack or stand as a tom. Impossible with most triggers; no problem with the DTB-PRO triggers from 682Drums.

How to mount the DTB-Pro
Mounting is easy. Just put the four ends of the ribbon on the shell edges. Place your mesh head or acoustic head over the ribbon ends, replace your rim and tighten as you normally would.

When using mesh heads, you can mount the 6.3mm jack output in the air vent of your shell. If you are using acoustic heads, the air vent is needed. You can then choose either to drill a 2nd hole in the shell ( don't forget a new air vent grommet) or run the trigger wire through the standard air vent and install a connector outside of your shell.
Check our YouTube video:
$55.00 -
Article code: 261025
EAN: 0700465732903
By using our website, you agree to the usage of cookies to help us make this website better. Hide this message More on cookies »